Installation Guide

Salon™ Spa Bath
Page 16 www.jacuzzi.com Installation and Operation
English
General Operation Information
Fill to at least 1˝ to 2˝
above highest jet
All bathtubs manufactured by Jacuzzi Luxury Bath are
designed for “ll and drain,” which means the bathtub
should be drained after each use and lled with fresh
water by the next bather. This is a health precaution,
as these bathtubs are not designed to hold water
continuously like pools or spas.
Two control panel types are available for the Luxury
Salon Spa series. Refer to details below:
•
J4 Luxury Electronic Control Panel:
Operational instructions for this panel is listed
below.
•
Optional J5 Luxury LCD Control Panel:
Operation instructions for this panel are outlined in
the supplemental guide provided in your warranty
pack. Refer to this document for complete operation
details (P/N GU47000).
Close the drain and ll the bathtub until water is at least
1˝ to 2˝ (25mm to 51mm) above the highest jet (see
water line indicated in the illustration). Do not turn on the
whirlpool system at any time if the jets are not completely
immersed in water. Running the whirlpool system when
there is insufcient water in the bathtub could result
in water spraying outside the bath area. Running the
whirlpool system without sufcient water will damage the
recirculating pump.
When exiting the bathtub, the water level will drop
below the jets which could result in water being
sprayed out of the unit. To prevent this, you must
turn unit OFF before exiting bathtub.
J4 Control Panel
J5 Control Panel
The last blower setting used is remembered by the
system and will automatically resume upon next
use.
When the blower is turned off, operation does
not immediately cease. There is a delay of 15-20
seconds to allow the blower to cool down. The unit
is shutting down, as indicated by the blinking of
indicator lights.
If in chromatherapy lighting, or whirlpool, mode
(indicator lights are dim), you will need to press the
blower button once to resume blower operation
mode and then a second time to turn the blower
power off.
ON: Press the blower button once to turn the
blower ON.
The indicator light(s) at right will illuminate brightly. The
blower is on a timer and will operate for 20 minutes.
OFF: Press the blower button a second time to turn
the blower OFF.
These lights will
be blinking
POWER
Main Menu
Jet Air
Air
Blower Operation