Installation Guide

Salon™ Spa Bath
Page 20 www.jacuzzi.com Installation and Operation
English
Controlling Whirlpool Direction and Flow
Direction -
All Jacuzzi jets, except the rotating neck jets, can be driectionally
adjusted. To change the direction of the water ow, swivel the jet
nozzle to the desired angle. The jets can be directed individually
toward any location on your body to provide a hydromassage.
The jets can also be adjusted so that they all point in the same
direction (clockwise or counterclockwise) to circulate the water in
a circular motion around the bath, causing a total whirlpool effect.
Water Force -
Most Jacuzzi jets are designed for ow adjustment. For robust
action, increase the force of the ow by rotating the nozzle, or
face, to the left (counterclockwise). For a more gentle effect, or to
close off the jet, rotate the nozzle, or face, to the right (clockwise).
Closing one or more jets can increase the water force in the
remaining jets.
The rotating neck jets, and some AccuPro™ jets, cannot be
adjusted for water force.
Never run the whirlpool system with all the jets closed.
Press light button 1st time:
Turns colored lighting ON, use up and down buttons to start
color scroll or select alternate color.
Press light button 2nd time:
Turns white lighting ON, use up and down buttons to select
intensity of white light.
Press light button 3rd time:
Turns all lighting OFF
Colored Lighting Operation
The colored lighting default is constant blue. Pressing the (+) button activates color scroll in this order: blue, teal,
green, yellow, orange, red, pink, purple and then returns to blue and continuously repeats. To stop on a selected color,
press the (+) button again. Pressing the (-) button activates color scroll in this order: blue, purple, pink, red, orange,
yellow, green, teal and then returns to blue and continuously repeats. To stop on a selected color, press the (-) button
again.
White Lighting Operation
There are ve white light intensities. Press the (+) button to increase light intensity. Press the (-) button to decrease
light intensity.
Chromatherapy or Illumatherapy (Light) Operation
Multidirectional Jets
Wave Mode
Press the wave button to cycle the air ow in the jets
from maximum to no air ow.
If the wave mode does not initiate, ensure that you are
in whirlpool operation mode (lights immediately to the
left of the jet button should be brightly lit).
Both right and left air valves are cycled simultaneously
from a closed position (no air) to open.
The indicator lights will display the ow as it cycles from
minimum to maximum. To turn off wave mode, press the
(wave) button.