Installation Guide

3
ASSEMBLY INSTRUCTIONS / INSTRUCCIONES DE EMSAMBLAJE
1 2
4
2
1
3
3
4
2
1
3
5
Shut off the water supply. Remove old
faucet. Clean sink surface in preparation for
new faucet.
OPTIONAL FLANGE INSTALLATION:
Remove the preassembled lock nuts (1)
and washers (2&3) from the faucet. Before
installation, ensure that the ange (4) is
placed on the bottom of the new faucet.
Place the faucet through the mounting holes
in the sink until the faucet sits on top of the
sink. From underneath the sink, secue the
faucet assembly with the rubber washer (3),
metal washer (2) and lock nuts (1). Use a
wrench to tighten the lock nuts (1).
OPTIONAL DECK PLATE
INSTALLATION:
Remove the preassembled lock nuts (1)
and washers (2&3) from the faucet. Before
installation, remove the ange. Align the
hole in the gasket (4) and deck plate (5) and
mounting hole in the sink. Place the faucet
through the deck plate (5) and mounting
hole in the sink until the faucet sits on top of
the deck plate (5). From underneath the
sink, secure the faucet assembly with the
rubber washer (3), metal washer (2) and
lock nuts (1).
NOTE: If the sink is uneven, use silicone
(not included) under the gasket (4).
Apague el suministro de agua. Quite el grifo
viejo. Limpiar la supercie del fregadero en
preparación para el nuevo grifo.
INSTALACIÓN DE BRIDA OPCIONAL:
Retire las contratuercas preensambladas
(1) y las arandelas (2 y 3) del grifo. Antes de
la instalación, asegúrese de que la brida (4)
esté en la parte inferior del nuevo grifo.
Inserte el grifo a través de los oricios de
montaje del lavabo hasta que el grifo se
asiente en la parte superior del lavabo.
Desde debajo del lavabo, asegure el
ensamble del grifo con la arandela de goma
(3), la arandela de metal (2) y las con-
tratuercas (1). Use una llave inglesa para
apretar las contratuercas (1).
INSTALACIÓN DE LA PLACA DE LA
PLATAFORMA OPCIONAL:
Retire las contratuercas preensambladas
(1) y las arandelas (2 y 3) del grifo. Retire la
brida antes de la instalación. Alinee el
oricio de la empaquetadura (4) y de la
placa de la plataforma (5) con el oricio de
montaje del lavabo. Coloque el grifo a
través de la placa de la plataforma (5) y del
oricio de montaje del lavabo hasta que el
grifo se asiente en la parte superior de la
placa de la plataforma (5). Desde debajo
del lavabo, asegure el ensamble del grifo
con la arandela de goma (3), la arandela de
metal (2) y las contratuercas (1).
NOTA: Si el lavabo está disparejo, utilice
silicona (no se incluye) debajo de la
empaquetadura (4).