Operation Manual

44
If the base already has the maximum number of six handsets registered, you will
need to deregister one of the existing handsets before you can register the new
handset. See section I.2. Deregister a handset or a base.
On the handset:
Enter the base PIN code.
Pre-set base PIN code is 0000.
When in standby, the new handset number will be displayed.
The handset will automatically be allocated with the next available handset
number.
If the registration is unsuccessful, the display will show “Not registered” and
you will need to follow the registration procedure again. The display will show
“searching” if the handset is registered but cannot locate the base, for example
when the base station is out of range or turned off.
I.2. Deregister a handset or a base
If you have more than one handset registered to your base or more than one base
registered to your handset(s), you can deregister both the handset from the base
or the base from the handset. Before deregistration, make sure that all handsets
and the base are in standby.
Key Map:
Add. Settings Deregister select the handset or
base select Yes
1. Press to access the main menu.
2. Press
/ to select “Add. Settings” and press
3. Press / to display “Deregister” press to confirm.
4. Press
/ to select “Handset” or “Base” and press to confirm.
5. Press
/ to select “Yes” and press
6. Press
to exit and return to standby.
I.3. Changing the PIN code
Key Map:
Setting Base Base PIN enter a new PIN code
The default Base Pin code is 0000. If you want to change to a new PIN code, follow
the above procedures while you enter a new 4 digits base PIN code.
I.4. Selecting a base
You can register the handset with up to 4 bases, e.g. one at work and one at
home or one upstairs and one in the garage, and switch between them. Once your
handset is registered with other bases, you can either specify the base you want to
use or, select “Automatic” for your handset to choose your base with the strongest
signal.
Key Map:
Add. Settings Base Select Automatic or
Base number
1. Press to access the main menu.
2. Press
/ to select “Add. Settings” and press