Installation Sheet

j a c l o i n d u s t r i e s | 129 Dermody Street Cranford, NJ 07016
p 908.653.4433 f 908.653.1717
06.13.19
JACLO.COM
|
PG 2
**IMPORTANT**
WATER FLOWS FROM BOTTOM PORT OF VALVE FIRST.
If using valve for 2 functions, plumb desired
rst function from bottom port.
Upper
Cartridges
(Varies)
Trim Ring
Limit stop
Trim Cap
(Trim varies)
Lower
cartridge
VALVE INSTALLATION
1. Turn off water supply.
2. Install valve in rough wall blocking within min.
max. dimensions to nished wall. Figure 1
3. Remove plastic roughing shield.
4. Turn off hot and cold stops. Figure 2
5. Remove trim ring.
6. Remove upper and lower cartridges and store in
clean package.
7. Connect hot and cold piping to valve. Figure 4
8. Connect shower and or tub piping to valve. Install
pipe plug on any unused port. Figure 4
9. Turn water on.
Supplied
Separately
Supplied
Separately
Finished
wall
Finished
wall
Supplied Separately if used
Figure 1 (with Diverter)
Figure 1 (without Diverter)
PBV
CSV
Figure 3
Figure 5 Figure 6
Cap
Hot Stop
Valve
Cold Stop
Valve
Figure 4
Lower
Higher
Faceplate
Gasket
Longer Screw
Figure 2
UP
H C
DOWN
10. Place a suitable container under valve and turn on hot
and cold stops. Run water until it is clear and free of
debris.
11. Turn off hot and cold stops.
12. Clean inner valve body.
13. Reinstall lower and upper cartridges. Installation tip:
use a little silicone grease to keep seals in place
during installation.
14. Install trim ring.
15. Open hot and cold stops and check for leaks.
16. Repeat steps 11-13 if leak is found.
17. Reinstall plastic roughing shield.
Plug (Not included)