Rack Conveyor Dishmachine Maintenance Instructions Motor Assembly Replacement 07610-003-20-17 March 14, 2006
MAINTENANCE INSTRUCTIONS REPLACING CONVEYOR MOTOR The instructions provided here are for maintenance personnel only. Unauthorized persons should not attempt any of the steps contained in these instructions. STEPS 1. Remove the (4) nuts holding the mounting plate in position. Warning: many of the instructions and steps within this document require the use of tools. Only authorized personnel should ever perform any maintenance procedure on the dishmachine! PREPARATION 1.
MAINTENANCE INSTRUCTIONS REPLACING CONVEYOR MOTOR Removing the pump gasket Removing the rear clamp 10. Remove the wiring cover on the new motor assembly and pull the wires free. Install the conduit fitting. 4. Remove the motor support bracket. 11. Run the conduit to the motor, pulling the machine wires through and into the motor wiring box. 12.
MAINTENANCE INSTRUCTIONS REPLACING CONVEYOR MOTOR SPECIAL PARTS 16. Attach the motor support rear clamp. Bracket, Motor Support 05700-021-73-42 17. Adjust the motor support bracket so that the motor assembly is level and tighten down. Clamp, Motor Support 04730-002-32-15 18. Attach the motor wiring cover. CONTACT INFORMATION AFTER MAINTENANCE ACTIONS Jackson MSC Inc. provides technical support for all of the dishmachines detailed in this manual.
