Instructions / Assembly

Installation:
1. The 24 in. Drainage Cover will fit most 24 in. installed risers. Test fit the 24 in. Drainage
Cover to make sure it is correct for your riser.
2. Clean the sealing surface of your riser.
3. Remove the hardware pack containing the four square-drive screws from the back of the 24
in. Drainage Cover.
4. Place the 24 in. Drainage Cover on your riser. Make sure the rubber seal is making a seal
with the top of your riser.
5. Using the four screw holes in the cover as a guide, drill four 3/16 in. holes through your riser.
6. Some risers may require the use of holes other than the molded screw holes into the 24 in.
Drainage Cover. For these risers, use the two additional drill points molded on the top of the
cover.
7. Install the provided screws with a #3 square driver.
8. For access to your riser just remove the screws and cover, then reinstall as above.
Safety Information:
Warranty:
www.jackelinc.com
574-256-5635
!
WARNING: Make sure all screws are tightly fastened.
Package Contents Tools Required
Safety Goggles
3/16 in. Drill
For more information please visit our website: www.jackelinc.com/warranty
Installation Guide
24 in. Drainage Cover
Model: SFDC24-B
Cover
4 x Screws
#3 Square Driver