Use and Care Manual

CORPORATION
800 East Third Street
Buchanan, Michigan 49107-1803
Customer Service 1-800-800-4950
Mon. thru Fri. 8:00am – 8:00pm EST
E-mail [e-mail]
English-Spanish-French
© 2018 Jack-Post Corporation ZI-5049-6 08/18
WARNINGS:
Missing hardware?
Please call our customer service department at 800‐800‐4950
This glider is tested up to 500 lbs.
Best if stored under a covered porch or area.
Arm .
Arm .
Front Brace .
Back Brace .
Left Base .
Right Base .
Seat Connector.
Seat Connector.
C
C
Step 3. Assemble the Seats .
Connect the two seats and back together with the seat connectors (C).
Do not tighten hardware.Leave hardware loose until last step.
Step 7. Tighten hardware using the two wrenches provided (T and U) .
Add plastic screw caps (Q) to the outside of the hardware.
Step 5. Build the Base.
Attach the left base (E) and the right base (F).
Be sure the barings are facing out.
Step 6. Attach the bench to the base.
H
E
F
G
FRONT
K
N
S
S
N
P
M
N
S
S
N
P
D
D
P
N
N
L
L
N
J
J
J
J
J
J
J
J
N
N
N
N
N
N
N
N
N
L
N
M
N
P
1 5 m m
1 5 m m
1 5 m m
1 5 m m
5 0 m m
FRONT
N
S
N
P
M
5 0 m m
3 7 m m
5 0 m m
3 7 m m
3 2 m m
Step 4 . Attach arms (D) to back seats.
R
Q
NOTE:
Test the operation of the glider. Gliding motion should be smooth.
If nuts and bolts are either too loose or too tight, glider will not function
properly or safely.
Adjust the tension by tightening or loosening the glider brackets,
nuts and bolts.