STAINLESS STEEL Model # SSMT1000 Item # 108709 Distributed by OPERATING MANUAL V1 021306
TABLE OF CONTENTS 3 4 5 6 8 9 10 2 Exciting Offers from the . . . . STAINLESS STEEL Important Safety Information Helpful Hints Replacement Parts Kit #1 Filter Blade Parts List Replacement Parts Kit #2 Lid with Pulp Guard Pulp Collector Crescent Tool Pusher Assembly Call Toll-Free 1-800-526-2518 Please allow 4-6 weeks for shipping. Disassembly YES! Please Send Me the following Items: ■ Replacement Parts Kit #1 for only $19.99 plus $6.99 s&h. Total $26.98.
TROUBLESHOOTING Problem The motor does not run after being switched on. Possible Reasons and Solution • Check to see if unit is plugged in. IMPORTANT SAFEGUARDS READ THESE SAFEGUARDS CAREFULLY BEFORE USING THIS PRODUCT! • NOT FOR USE BY CHILDREN! Keep out of the reach of children to avoid injury. This appliance is not a toy. • Locking bar is not locked in place properly. • Make sure the lid is attached properly and securely locked before operating the Power Juicer.
HELPFUL HINTS Obtain the best results from your Jack LaLanne Power Juicer by following these helpful hints. • Do not put any fruit or vegetables in your machine until power is turned on. • Allow unit to run for at least 10 seconds before juicing. • Do not force food into the juicer. Allow food to pass through slowly and steadily using the pusher. You do not need to apply pressure unless the juicer starts to vibrate. Then only a slightly harder push should bring it back to balance.
DISASSEMBLY 1 Pusher IMPORTANT: Before disassembling the unit make sure you turn the power OFF and unplug the machine from the electrical outlet. PARTS LIST 2 MAIN UNIT (Fully Assembled) Locking Bar Pusher Pulp Guard Pulp Collector STEP 1: Remove pusher from the chute. 3 STEP 2: Lower the locking bar (silver) into position as shown. Lid with Pulp Guard 4 Chute Blade Filter Crescent Tool Pulp Collector STEP 3: Remove lid with pulp guard, and pulp collector.
ASSEMBLY 1 ASSEMBLY (CONT.) Assemble as shown STEP 5: 2 Base Locking Bar Lip Juice Spout Receptacle Base Front of Machine Place lid with pulp guard attached on top of receptacle, making certain it is snugly aligned with the pulp guard facing in the opposite direction of the juice spout. Lock lid into place by lifting locking bar up until it clicks into grooves located on both sides of the lid. Make sure locking bar is in the full upright, locked position.
