Operation Manual

CR-11A Expander Module 2/4 MEI51205 CR-11A Expander Module 3/4 MEI51205
mode
no.
DIP switch
settings
Function of relay no. 1 Function of relay no. 2
1
1 sec. pulse after simultaneous
pressing of A&B buttons on the remote
control, when car alarm
is armed
1 sec. pulse after simultaneous
pressing of A&B buttons on the remote
control, when car alarm is disarmed
2
relay will change status after
simultaneous pressing of A&B
on RC, when car alarm is armed /*
relay will change status after
simultaneous pressing of A&B,
on RC, when car alarm is disarmed /*
3
left flasher output signals
(arming, disarming, alarm)
right flasher output signals
(arming, disarming, alarm)
4
lock (pulse duration selectable in the car
alarm setting mode)
unlock (pulse duration selectable in the
car alarm setting mode)
5
immobilization (relay switches ON when
car alarm is disarmed and the ignition
key is ON)
alarm (relay switched ON during
alarm condition)
6
immobilization (relay switches ON when
car alarm is disarmed and the ignition
key is ON)
arming signals (1 pulse = arming,
2 pulses = disarming)
7
courtesy (Dome) light control (relay
follows door switches + 1 minute) /**
arming signals (1 pulse = arming,
2 pulses = disarming)
8
immobilization (relay switches ON when
car alarm is disarmed and the ignition
key is ON)
courtesy (Dome) light control
(relay follows door switches + 1 minute)
/**
9
double locking impulse – during
arming relay will be switched ON for
0.3s, then switched OFF for 1s and
switched ON for 0.3s again
double unlocking impulse – during
disarming relay will be switched ON for
0.3s, then switched OFF for 1s and
switched ON for 0.3s again
10
Second locking impulse – 1s after
preset locking car alarm impulse, relay
will be switched ON for 0.5s
Second unlocking impulse – 1s after
preset unlocking car alarm impulse, relay
will be switched ON for 0.5s
11
controlling of relay via SMS – only for
CA-180x, see CA-180x manual for more
details
controlling of relay via SMS – only for
CA-180x, see CA-180x manual for more
details
/* with each simultaneous press of the A&B buttons, the relay will toggle status (on - off - on ...). The relay will
also switch off for 15 minutes or after arming or disarming
/** the courtesy (Dome) light is on while a door is open (max. 15 minutes) and it will remain on until you
switch on the ignition key (max. 1 minute)
Examples of use
1. Trunk (boot) release by simultaneous pressing of A&B buttons on the remote control
Select mode no. 1 on the CR-11A module and disable the Panic alarm in the car alarm settings (if this
feature is supported). Opening the trunk (boot) by remote control is only possible when the car alarm is
disarmed.
2. Additional immobilization and an additional siren
Select mode number 5 on the CR-11A module. The additional immobilization provides a higher security
level, because it is impossible to bypass it even when somebody is tampering directly with the wire harness
of the car alarm unit (the CR-11A is waiting for digital data from the car alarm). The additional siren sounds
during the alarm period (the car horn can also be used as an additional siren).