Installation Instructions

GSM pager CA-1803BT „Athos“ 6/6 MHF56803
factory defaults, including access codes (stated in the manual). Caution:
all pre-programmed numbers, Locator parameters, DIP and SET
parameters will be deleted. You perform an emergency reset as follows:
Turn the power supply (including back-up battery, if any) off. Pull the SIM
card out of the car alarm and insert it into a phone, enter “RESET” as a
name into the SIM card’s phone directory, and enter “0” for the
corresponding phone number. Insert the SIM card back into the car
alarm and turn the power supply on. The reset is indicated by 4 beeps.
Please contact us by phoning [phone] or [phone].
You can also e-mail us your suggestions to improve our services and
products to [e-mail]
.
17. Specification
Power supply 12/24V DC (8-32V)
Stand-by consumption max. 20 mA
Max. consumption (during GSM communication) 1 A
GSM band E-GSM / GPRS 900/1800MHz
Transmitted power 2 W for GSM900, 1 W for GSM1800
Frequency 868.5MHz
Operational temperature -20°C to +70°C
Output SIR +12V (24V), max. load 1.3A
Immobilization 8A permanently, 12A intermittently
Central locking outputs max. 200mA, to GND
pulses 0.5s, 4s or 60s (optional)
Complies with ECE Regulation No. 97.00
Can be operated according to ERC/DEC98(20,21),ERC REC 70-03
Safety EN 60950
EMC EN 55022, EN 50130-4
Radio interference ETSI EN 301419-1, EN 301511,
ETSI EN 300220, ETSI EN300 328
JABLOTRON ALARMS a.s. hereby declares that the CA-1803BT is in
compliance with the essential requirements and other relevant
provisions of Directive
1999/5/EC and 1995/56/EC The original of the
conformity assessment can be found at www.jablotron.com
, Technical
Support section
Note: Although this product does not contain any harmful materials we
suggest you return the product to the dealer or directly to the producer
after use.
97RAI-01 4532
E
8