Installation Instructions

GSM pager CA-1802 „Athos“ 2/5 MHF57402
By enrolling the first remote control all other remote controls previously
enrolled will be erased (so enroll all the controllers intended for use, one
by one).
5. Exit enrollment by turning the ignition off. The GSM pager confirms the
enrollment by sending an SMS message to authorized phones TEL1 to
TEL4.
If no siren has been connected, it is necessary that after finishing the enrollment
you verify that all key fobs are enrolled Pressing any button on the RC-8x controller
causes a LED of the GSM pager to flash.
Fig. 1: Wiring the alarm in RESET 3 mode. Wiring the alarm this way makes it possible to control the car’s central locking.