Installation Instructions
GSM car alarm CA-1802 „Athos“ 6/6 MHF57202
after the recovery of the main power supply voltage (at least 10
minutes).
15. Emergency RESET
In the case of an emergency, when no installation MASTER code is
available, it is possible to perform an emergency RESET of the car
alarm even without the code. Such a reset causes the car alarm to be
set to factory defaults, including access codes (stated in the manual).
Caution: all pre-programmed numbers, Locator parameters, DIP and
SET parameters will be deleted. You perform an emergency reset as
follows: Turn the power supply (including back-up battery, if any) off.
Pull the SIM card out of the car alarm and insert it into a phone, enter
“RESET” as a name into the SIM card’s phone directory, and enter “0”
for the corresponding phone number. Insert the SIM card back into the
car alarm and turn the power supply on. The reset is indicated by 4
beeps.
Please contact us by phoning +420 483 559 987. You can also e-
mail us your suggestions to improve our services and products to
auto@jablotron.cz
.
16. Specification
Power supply 12-24V DC (8-32V)
Stand-by consumption max. 20 mA
Max. consumption (during GSM communication) 1 A
GSM band E-GSM / GPRS 900/1800MHz
Transmitted power 2 W for GSM900, 1 W for GSM1800
Frequency RX 868.5MHz
Operational temperature -20°C to +70°C
Output SIR +12V (24V), max. load 1.3A
Immobilization 8A permanently, 12A intermittently
Central locking outputs max. 200mA, to GND
pulses 0.5s, 4s or 60s (optional)
Complies with ECE Regulation No. 97.01
Can be operated according to ERC/DEC98(20,21), ERC REC 70-03
Safety EN 60950-1
EMC EN 55022, EN 50130-4
Radio interference ETSI EN 301 419-1, EN 301 511, ETSI EN 300 220
JABLOTRON ALARMS a.s. hereby declares that the CA-1802 is in
compliance with the essential requirements and other relevant provisions
of Directive 1999/5/EC and 1995/56/EC The original of the conformity
assessment can be found at www.jablotron.com
, Technical Support
section
Note: Although this product does not contain any harmful materials we
suggest you return the product to the dealer or directly to the producer after
use.
97 RAI-01 4532