Operation Manual

MLO51201 - 16 -
Listening in
You can trigger listening-in via the voice menu (must be enabled for each user).
You can listen to what is happening in the guarded premises for up to 3 minutes.
Tips and specifications
 Do not test listening-in from the same room as the GSM control unit is installed. There is a
risk of strong audio feedback between the telephone receiver and Azor’s microphone
(listening-in is very sensitive).
 You can only listen, it is not possible to speak to the premises.
 If an alarm is triggered during the listening-in, the listening-in is interrupted automatically.
 If the listening in is started during the alarm, the siren is blocked and reports are sent
immediately after the end of the call.
Informative SMS
You can request sending an informative SMS in the voice menu. This message contains:
1. Azor’s current status
2. last event saved in the memory (e.g. who set the system, what kind of alarm was
triggered, etc.)
3. power supply status
4. GSM control unit backup battery status
5. GSM signal strength in percent
6. system operation time since the last switching on
7. registration code (serial number) of Azor
Tips and specifications
 If the GSM network provides an exact time function, the informative SMS comprises of time
as well. Azor’s internal clock can also be set from a connected PC – see the Settings.
- 9 - MLO51201
RFID tag reader installation
 Install the RFID tag reader at the door (the magnet should be in the bottom left corner of
the bottom frame). If the reader is to be installed in a concealed box, insert the magnet in
the top frame of the reader.
 Connect the batteries and close the reader (the LED indicator should be at the top).
 Switch on the GSM control unit and test its functioning.
Switching the GSM control unit on for the first time
1. Find a concealed place near a socket.
2. Open the battery cover, remove the insulation strip and close the cover (A).