Operation Manual

MLO51201 - 20 -
alarm.
AZ-10S optical smoke detector
The detector reports fire hazards. It is
activated by the presence of smoke or an
abnormal temperature increase. Besides
sending a report to the system, it also
triggers its own siren during an
 Screw the detector holder to the ceiling
 Use the computer to enroll the detector to the system (see the Settings)
 Connect the battery and twist the detector onto the holder
 Wait until the detector LED indicator goes off (calibration is in progress)
 Test the detector – see the Communication test chapter. Activate the detector by
pressing and holding its testing button.
Tips and specifications
 The detector cannot be twisted onto the holder if no battery is connected.
 Install the detector onto the ceiling in a place with good air circulation (i.e. avoid corners,
hollows, tops of inclined ceilings, etc.).
 If the space (or ceiling) is divided by partitions which prevent free air movement, each
section should have its own detector.
 The detector should not be installed close to ventilators, heaters, ventilation openings or in
dusty premises.
 It is not recommended to install the detector close to cookers, hot plates or anywhere where
steam is produced.
 A suitable place to install an optical smoke detector is a ceiling above the staircase in the
house.
 Never test the detector with fire; use a special spray designed for smoke detector testing to
simulate fire.
 When an alarm is indicated, the siren can be switched off by pressing and holding the test
button.
 The detector siren can be disconnected completely – by disconnecting its cable connector
(near the negative pole of the battery).
 If people smoke in the room during normal operation, you can program Azor to react only
when set – see the Settings. In such a case disconnect the siren in the detector as well. Do
not forget to ventilate the premises before setting the alarm.
 All jumpers in the detector must remain disconnected.
Battery-low signalling
When the detector battery is low, Azor sends an informative message. Besides that, the
smoke detector flashes and beeps approx. every 45 s.