Operation Manual

- 19 - MLO51201
seconds.
AZ-10P motion detector
Internal switches:
1 HIGHER ANALYSIS the detector has increased resistance to false alarms and a
slower reaction
STANDARD ANALYSIS the detector has standard resistance to false alarms and a
standard reaction speed
2 INSTANT REACTION the detector does not provide an entrance delay*
DELAY REACTION the detector provides an entrance delay*
*) applies only if a “default” reaction is set for the detector – see the A-Link settings
Frequent movement detection restriction
When in normal operation the detector saves energy by switching the sensor off for 1
minute each time it detects motion. This ensures that it does not transmit too frequently if
there is frequent movement in the premises.
Battery-low signalling
When the detector batteries are low, Azor sends an informative message. Besides that,
the detector LED flashes when movement is detected (outside test mode).
AZ-10R remote control
The remote control can be used for setting and
unsetting. It can also send a panic alarm – by pressing
both buttons at the same time. The panic alarm function is
optional – see the Settings. The remote control battery
should last approx. 2 years. The enrollment code is sent
when both buttons are pressed for more than 3
The remote control cannot be used close to the control unit!
AZ-10B doorbell button
One doorbell button can be enrolled. You can choose a
melody (see the Settings). The doorbell button battery
should last approx. 1 year.
The button should be protected from rain (it is supplied
with a plastic roof).
The button cannot be used close to the GSM control unit.