Operation Manual

- 11 - MLO51201
Installation of the GSM control unit and its antenna
 The GSM control unit should be installed in a concealed place. There must be
a mains socket for the connection of the supplied mains adaptor within reach.
 If the LED indication on the front panel of the control unit is unwanted (may
show the place of unit installation) it is possible to switch it off using A-Link.
The LED indication is switched off within 15 minutes. If you need to check the
indication briefly press the button on the unit and the indication will appear for
15 minutes. In the case of power trouble the LED indication is always on.
 No other electronic appliances should be near the GSM control unit (e.g. audio
systems, antenna cables) which may be influenced by the GSM transmitter in
the control unit.
 You can use the template at the rear of the manual to mark the spots where
you want to fix Azor to the wall. The screws should protrude a bit so that the
electronic box can be put on the screw heads and secured by moving it
sideways.
Tamper detector
The GSM control unit has a sensitive tamper-switch at the bottom (a plastic
lever). Based on its activation by picking up the GSM control unit, the system sends
a tamper activation report to the user or ARC if enabled.