User Manual

2. Choose “Splicing SETUP”, When the Horizontal Count and Vertical Count is the same,

there will be no deformation on the image.

3. When cascade for NXN video wall , the output which cascade for next layer should be

set as “1x1”, other outputs should be set as your required”NXN”.

For example, if you need cascade for “3x3”, the output 1 need to connect with next Video

Wall Controller , then the output 1 should be set as “1x1”, output2 to output4 should be set

as “3x3”.

4. After setting the Horizontal Count and Vertical Count, press “ ” to turn on /off the

video wall mode

9.4. Menu Reset

Choose “Menu Reset” to res tore factory s etting.