Installation Manual

to direct our ping request to the device/host itself and sends an echo message back to say that it
cannot be found. Most likely there is not a device on your LAN that is using the 192.168.1.200 IP
address.
If your results show the following, there is a device/host on your network with that IP address
already. In the example below, the results from command ‘ping 192.168.1.10’ show that there is a
device on the LAN at that IP address responding to our ping request.
If there is a device using the IP address 192.168.1.200 on your network, try to ping another IP address
like 192.168.1.201 until your results show “Destination Host Unreachable”.
Once you have found an unused IP address on your network, write this IP address down as it will
become the static IP address of your encoder. In the examples above, we know that the IP address
192.168.1.200 is not being used by a device on our network and will become our encoder’s static IP
address.