User Manual

Programmable Control Panel

output. RS232 (2) and IR3 share the same port, the detailed use depends on the

setting of JTD-Control.

Other part is RS232 (3), it can be used for control other devices or looping output,

or connect with PC.

These two parts share the same grounding.

② This port includes: RS232 (1)/IR2, IR1 and RS485.

a) RS232 (1)/IR2: share the same port, the detailed use depends on the setting of

JTD-Control. When be used as RS232, it is unidirectional transmission,

transmit data but without receive.

b) IR1: for control other devices, it can be programmable by the JTD-Control.

c) RS485: the RS485 can be programmed as different commands and control the

device with RS485 port. The command of RS485 is the same as RS232 (1).

③ Low-Voltage relay ports: set the relay on/off by software JTD-Control

④ Power connector: 12VDC. Be sure that the “+” and “-” never be mixed or

wrong connection.