User Manual

Programmable Control Panel
11
The output port set in JTD-Control and the port used in the programmable control
panel is corresponding. And there are four output types. They are showed as below
form (“√” means port is available):
Output port of
the Panel
Output mode
of JTD-Control
IR1
RS232(1)
IR2
RS232(2)
IR3
RS232(3)
RS485
RS232(1)(2)
√
√
√
√
√
RS232(2),IR2
√
√
√
√
RS232(1),IR3
√
√
√
√
√
IR2,3
√
√
√
√
3) Connection type: the instructions are in the picture below:
The functions of the programmable control panel’s buttons will be available only
after the programmed data is uploading successfully.
1：Com, connect by serial port.
2：USB, connect by mini USB.
3：Disconnect, disconnect the
connection.
4：Upload: upload the programmed
data to the programmable
control panel. It will clear all the
old data in the programmable
control panel.
5：Clear, clear the data in the
programmable control panel.