Application Guide

On the “Action List” section you will see all the command and actions are set up. The only thing
you need to do is load this configuration to the JTD-P8. You also can modify the set up on the
“Event Set” section to your preference.
3.5 Click “Connection”, select “upload” then click “OK” to Clear all data stored in the JTD-P8.
Wait about 30 seconds until you see the green progress bar disappear.
3.6 Click “Connection” then select “Disconnect”. Next, unplug the USB cable from your
computer. Now power circle the JTD-P8.