User Manual

Operating Instruction

 Click "OK" to enter the next submenu.

 Press the “up and down” button to select the "CH0" to close or the "CH1" is open

 Click the "OK" button to complete the setting.

You can choose the Top area (one of the output port’s) to display CH0 or CH1.

8). CHO

Operation steps:

 In the main menu, select "Video" to press the "OK" .

 Press “ up and down” button to select "Output1" (The fifth ALL option means that all outputs

are selected)

 Click "OK" to enter the next submenu.

 press the “up and down” button to select "CH0"

 Click "OK" to enter the next submenu and there are two submenus of CH0: Crop,Zoom

 Press th e “up and down” button to select “Crop” to set Start x : 0, Start y : 0, End x :6000, End

y: 6000 (There are 61 subitems under each coordinate, minimum 0, maximum 6000, each value

interval 100, the defaults value of selected video:( th e upper left corner Start (0, 0), the lower right

corner End (6000, 6000), midpoint (3000, 3000))

 Click on the "OK"button to complete the setting.

 Press the “up and down” button to select “Zoom” . There are four subitems under Zoom: Start x:

0, start y :0, End x:3000, End y:3000;

 click on the "OK" button to complete the se ttin g.