Users Manual Part 2

J Plus, Inc
6.2.3.5
Neighbor Cell
From the tree menu, select Neighbor Cell to move onto the Neighbor Cell setup page. You can Add Neighbor
Cell and modify/delete a registered neighbor cell.
Please refer to Table 14 for detailed input parameter information. Like other setting procedure, the changes
must be saved.
Menu
Description
eNodeB Type
Select the type of Neighbor Cell.
IP Address
Insert IP address of Neighbor Cell for X2 HO.
Cell ID
Insert eNodeB ID of Neighbor Cell.
PLMN ID
Insert PLMN ID of the Neighbor Cell.
TAC
Insert TAC of the Neighbor Cell.
PCI
Insert PCI of the Neighbor Cell.
Insert DL EARFCN of Neighbor Cell.
DL EARFCN
This must be the frequency value included within EUTRA Frequency under basic
menu.
Insert UL EARFCN of Neighbor Cell.
UL EARFCN
This must be the frequency value included within EUTRA Frequency under basic
menu.
q-OffsetCell
Insert q-OFFSET of the Neighbor Cell.
Select X2 setup is enabled or disabled for the neighbor cell.
X2 Trigger
If X2 Trigger is disabled, S1AP based hand-out triggered.
If X2 Trigger is enabled, X2 based hand-out triggered.
Access Mode
Select the type of Access Mode.
CSG ID
Insert CSG ID of the Neighbor Cell
Table 14: Description of Neighbor Cell Parameter
www.juniglobal.com J Plus Proprietary and Confidential 52 / 98