Owner manual
Quick Reference Guide
For Your Safe Flight Page 62
1. Tap LF.
Automatic Scan
2. Tap STEP.
1. Tap
STEP to index to the
measurement to exclude.
Exclude Measurement in
Automatic Scan (toggle)
2. Tap both STEP and LF to toggle
exclude/include status.
3. Decimal point before
measurement name means it is
excluded from scan.
1. Hold
STEP and LF until the
display shows
PROGRAM,
followed by
Refuel ?.
Change Scan Indexing Rate
2. Tap NEXT, see Auto Scan Rate x.
3. Tap
PLUS or MINUS to change the
seconds per scan: 0 to9. Note: 0
disables auto scanning.
4. Tap
NEXT until you see End?Yes,
then EXIT to accept and exit.
1. Tap
STEP until x USD shown.
Reset USD (Fuel Used)
2. Hold both DIM and EGT/FF until
.0 USD is shown.
1. Hold the
LF and DIM buttons
simultaneously.
Display Hobbs
1. Insert USB Flash Drive into front
USB port on EDM.
Download Data in Memory
2. DOWNLOAD: NEW (latest flight)
or tap
CHANGE to see
DOWNLOAD: ALL (all stored
flights).
3. Tap
STEP and wait until
download progress bar completes
and normal display returns.
4. Remove USB Flash Drive.
1. Hold both
STEP and LF until the
display shows
PROGRAM,
followed by
Refuel ?.
Trip Mode (Accumulate Fuel
Used)
2. Tap NEXT until you see Trip
Used? No
.
3. To accumulate all fuel used, tap
Yes and see TRIP? Y.
4. Tap left button until you see
End
?Y and tap Yes to exit.