Owner manual

For Your Safe Flight Page 15
Linear Gauge Display Section
The linear bar graphs are arranged
in a three by three matrix on the
right half of the display. A typical
layout is depicted here (Note: your
actual configuration may vary).
Typical functions that can be
displayed are:
• Oil temperature
• Oil pressure
• Fuel pressure
• Bus voltage
• Amps (charge/discharge shown)
• OAT
• Fuel flow
• Left tank fuel quantity *
• Right tank fuel quantity *
* The fuel quantity gauges will not be
functional until the fuel calibration process has been completed.
The range of the bar graphs depends on the programming. Range,
redlines and/or limits are typically set to match the original aircrafts
gauge markings. These are locked for Primary installations, however
non-primary gauges can be user modified, using ‘EDM Config’ utility
downloadable from
www.jpitech.com. See ‘Section 9 - First Time Setup
and Customization’.
Note: Amps can operate either as a charge/discharge or load meter,
depending on programming. For charge/discharge, the center of the bar is
zero and the top and bottom are maximum charge and discharge,
respectively.