Owner manual

Table of Contents
Section 1 - Getting Started 1
Fuel Flow Computer Basics 2
Control Button Basics 2
Display Screen Basics 2
Remote Auxiliary Display Basics 3
RPM and MAP Display Basics 3
Linear Bar Graphs Display Basics 3
LeanFind Basics 4
Section 2 - Interpreting Data 5
Operation for each Phase of Flight 5
Typical Normal Measurements 7
Engine Diagnosis Chart 8
Section 3 - Displays and Controls 11
Control Buttons 11
RPM and MAP Displays 13
Scanner Displays 13
Remote Auxiliary Display 16
Hobbs Display 16
Dimming the Display 16
Section 4 - Operating Modes 17
Manual Mode 18
Section 5 - LeanFind 19
LeanFind Procedure—General Explanation 23
Expanded Leaning Procedures 27
Section 6 - Fuel Flow Operation 28
Fuel Management 28
Start Up Fuel 29
Resetting ‘ USED’ 33
Trip Mode (Accumulate Trip Totalizer) 33
Scanner Fuel Flow Display Select 33
Section 7 - Alarms 34
Non-primary Alarm Priority 34
Section 8 - Memory and Data Download 35
Downloading Data from the EDM 35
Transferring data from the USB Flash Drive to a PC 36
Section 9 - First Time Setup and Customization 37
Adjusting the HP Constant for Rich of Peak Operation 40
Adjusting the MAP 40
Entering the K factor 43
Programming Trip Mode 44