Owner manual

For Your Safe Flight Page 12
2
nd
Button
In Automatic or Manual modes, tapping the
LF button will activate
the LeanFind mode.
In the LF mode holding the
LF button after peak EGT is found will
display the peak EGT.
In Automatic or Manual modes holding the
LF button for three
seconds will toggle between Standard and Normalize (NRM) views.
In the programming mode, tapping the
PLUS or MINUS button will
allow you to edit a parameter value.
Holding
LF during power up will display the primary alarm limits
after the self-test is complete.
1
st
and 2
nd
Buttons
Holding both the
STEP and LF buttons simultaneously for five
seconds will enter the pilot programming mode.
Just after entering Lean Find Mode (but before any EGT has risen),
holding both First and Second buttons for five seconds will toggle
between LOP or ROP leaning modes.
Tapping both the
STEP and LF buttons simultaneously in Manual
mode toggles to ‘include’ or ‘exclude’ the displayed non-primary
measurement from the Automatic mode. Note: Measurements are
never excluded from the Manual mode.
3
rd
Button
Tapping
DIM (brightness decreases) or holding DIM (brightness
increases) allows decrease or increase brightness respectively. Hold
on start-up to enter fuel level table
2
nd
and 3
rd
Buttons
Holding both the
LF and DIM buttons simultaneously will display the
Hobbs readings. Tap button labeled
NEXT to see additional
information screens..
4
th
Button ( ALL/EGT/FF )
Select what is shown during Scanner auto-sequence. Choices are
ALL, EGT or FF. Highlighted one is what is active. Hold on start-up
to enter fuel level readings.