User Manual

Page 2 Engine Data Management
Table of Contents
Section-1 Getting Started 4
View Angle 4
Rotation 6
Fuel Flow Computer Basics (independent of fuel quantity) 6
Display Screen Basics 7
Horizontal Display Mode 7
Vertical Display Mode 8
Remote Annunciate Light Basics 8
RPM and MAP Display Basics 9
Linear Bar Graph Display Basics 9
Scanner® Information Area 10
LeanFind Basics 11
Section 2 - Interpreting Data 12
Operation for each Phase of Flight 12
Typical Normal Measurements 14
Section 3 - Displays and Controls 17
Control Buttons 17
Scanner Displays 19
Additional Displays Hobbs, Revisions, and Alarm Limits 21
Dimming the Display 22
Section 4 - Operating Modes 22
Automatic Mode 22
Manual Mode 23
Section 5 - LeanFind 24
LeanFind Procedure—General Explanation 28
Expanded Leaning Procedures 31
Common Misapplications 32
Section 6 - Fuel Flow Operation 33
Fuel Management 33
Start Up Fuel 34
Resetting ‘USD’ 35
Trip Mode (Accumulate Trip Totalizer) 35
Scanner Fuel Flow Display Select 35
Section 7 - Alarms 36
Section 8 - Memory and Data Download 37
Downloading Data from the EDM 37
Transferring data from the USB Flash Drive to a PC 38
Section 9 - First Time Setup and Customization 38
Section 10 - Adjusting Manifold Pressure & %HP 41
Adjusting the HP Constant for Rich of Peak Operation 41
Adjusting the MAP 41
Adjusting the HP Value 42
Section 11 - Programming the Fuel Flow 42