User Manual

Page 10 Engine Data Management
Scanner® Information Area
The Scanner® Information Area provides expanded information in the form of
alpha-numeric messages, parameters and calculations. In Auto-Scan,
parameters will ‘scan by’ once every 4 seconds (default). This rate can be
changed in Pilot Programming Mode. Tap the STEP button for ‘Manual’ selection
of any parameter. Parameters for the installed options will be displayed. To start
the automatic scan tap LF and then STEP.
DISPLAY PARAMETER DESCRIPTION
EGT 1436 CHT 382 EGT/CHT
Shows successive pairs of EGT &
CHT per STEP tap.
TIT 1580
o
F TIT Single Turbine Inlet Temp.
TIT-L and -R 1490
o
F
TIT-L, TIT -R
Two Turbine Inlet Temp. Left and
Right engine side
Oil-T 204
o
F OIL TEMP Oil temperature in degrees F
Oil-P 64 PSI OIL PRES Oil pressure in psi
F-P16 PSI FUEL PRES. Fuel pressure in psi
F-F 2.7GPH FUEL FLOW Fuel flow in GPH
CLD 75
o
F
SHOCK
COOL
CHT cooling rate (deg/min)
VOLTS 13.9 BATTERY Battery/Bus voltage
AMPS -6 Amperage Set up per the specific aircaraft
OAT 23
o
F OAT Outside air temperature F or C
DIF 40
o
F DIF Hottest minus coldest EGT
CRB 56
o
F CRB
Carburetor Air Temp (only allowed if
IAT not present)
CDT 145
o
F CDT
Compressor Discharge Temp (only
allowed if CRB not present)
IAT 105
o
F IAT Induction Air Temp
Est. REM 68.0 GAL
FUEL
REMAINING
Calculated fuel remaining on board
based on what the pilot put in as
maximum.
WP REQ 12.7 GAL
FUEL
REQUIRED
Calculated fuel required to reach
waypoint or destination (GPS
interface must be corrected)
Est. WP REM 63 GAL
FUEL
RESERVE
Calculated fuel reserve at waypoint
(GPS interface must be correct)
ECON 9.8 MPG
Nautical
MILES PER
GALLON
Calculated fuel miles per units
(GPS interface required)
EST. T to E 04:32
H:M
Estimated
Time to
Empty
Calculated time remaining to fuel
exhaustion in Hours and Minutes at
present power.
GPH 15.0 GPH
FUEL FLOW
RATE
Actual fuel flow rate in Gallons per
hour
USD 7.2 GAL FUEL USED Actual fuel used by the engine
FUEL-P 64 PSI FUEL PRES Fuel pressure in PSI