User Manual

ManualsBrandsJ.P. Instruments ManualsEquipmentEDM 760 Flight Manual Supplement

FAA APPROVED

AIRPLANE FLIGHT MANUAL SUPPLEMENT OR

SUPPLEMENTAL AIRPLANE FLIGHT MANUAL (INCLUDING POH AND FAA

AFM)

(FOR THOSE AIRCRAFT WITHOUT A BASIC AIRPLANE FLIGHT MANUAL)

EDM-760 TEMPERATURE INDICATOR

FOR

Twin Reciprocating Engine Powered Aircraft as listed

on Approved Model List of

STC SA00729SE.

REG. NO.__________________

SER. NO. ____________________

This Supplement must be attached to the FAA Approved Airplane Flight Manual when the J.P.

Instruments EDM-760 is installed in accordance with Supplemental Type Certificate SA00729SE. For

those airplanes without a basic Airplane Flight Manual, the Supplemental AFM must be in the aircraft

when the EDM-760 is installed.

The information contained in this Airplane Flight Manual Supplement/ Supplemental Aircraft

Flight Manual supplements or supersedes the basic manual/ placards only in those areas listed. For

limitations, procedures and performance information not contained in this supplement, consult the basic

Airplane Flight manual, Markings and Placards.

Date: August 31,1999

Summary of content (4 pages)

PAGE 1
FAA APPROVED AIRPLANE FLIGHT MANUAL SUPPLEMENT OR SUPPLEMENTAL AIRPLANE FLIGHT MANUAL (INCLUDING POH AND FAA AFM) (FOR THOSE AIRCRAFT WITHOUT A BASIC AIRPLANE FLIGHT MANUAL) EDM-760 TEMPERATURE INDICATOR FOR Twin Reciprocating Engine Powered Aircraft as listed on Approved Model List of STC SA00729SE. REG. NO.__________________ SER. NO. ____________________ This Supplement must be attached to the FAA Approved Airplane Flight Manual when the J.P.
PAGE 2
J.P.INSTRUMENTS PO BOX 7033 1 HUNTINGTON BEACH CA 92646 Revision No. Description Airplane Flight Manual Supplement Document No. 760Rev NC Affected Pages Original Complete Flight Manual Supplement for EDM-760 1 thru 4 Page 2 of 4 Approval Mgr.
PAGE 3
J.P.INSTRUMENTS PO BOX 7033 1 HUNTINGTON BEACH CA 92646 I GENERAL Airplane Flight Manual Supplement Document No. 760Rev NC The EDM-760 twin temperature indicator displays temperature digitally and in analog format for both Left and Right engines simultaneously. The EGT as displayed is based on probes located near the exhaust outlet for each cylinder and the TIT probe, if installed, in the turbo charger inlet.
PAGE 4
J.P.INSTRUMENTS PO BOX 7033 1 HUNTINGTON BEACH CA 92646 Airplane Flight Manual Supplement Document No. 760Rev NC GENERAL (cont.) An alarm causes the digital function to flash as soon as the particular limit is exceeded. Factory set alarm limits for CHT (450 oF) and OIL (230oF) are lower than the actual aircraft limits and can not be set by the pilot. The values may be adjusted to suit individual preference by a qualified technician. Other factory set alarm limits are: "BAT" Voltage 15.5/11.0 or 31.0/22.