Installation Manual User guide

J.P.Instruments Fuel Flow Installation Manual Report # 503
for EGT-701 with Fuel Flow Option Page 4 of 14
Rev B : Date 03/14/97
3…. Installing the Fuel Flow Transducer:
Mount the Fuel Flow Transducer using the appropriate drawing at the back of this manual.
Aircraft Configuration Drawing #
Location
Page
1. All gravity Flow installations without fuel pump. Must use
FXT-231
700923
Between Fuel tank and
Carburetor.
8
2. All Fuel injected engines with vapor return lines to fuel tank , all
Continental and certain Lycoming engines.
700922
Between throttle body
and fuel flow divider.
9
3. All pump fed carbureted and Fuel injected engines without
vapor return lines.
700921
Between engine driven
pump and servo/throttle
body or carburetor
10
4. Pressure Carbureted engines with vapor return lines
700923
700920
One transducer in Carb
inlet line and one
transducer in out let line
8, 11,
12
The instructions listed below must be followed when installing a Fuel Flow Transducer.
Note: If your engine is equipped with a fuel return line from the carburetor back to the fuel tank you will need to install two
flow transducers... one in the feed line from the fuel pump to the carburetor and one in the return line from the carburetor back
to the fuel tank. Also, a Fuel Flow Differential Module (Dwg. 700920) will need to be installed.
The transducer output port should be mounted lower or even with the carburetor inlet port (or fuel servo on a fuel injected
engine). If this is not possible, a loop should be put in the fuel line between the Fuel Flow Transducer and the carburetor or fuel
servo (see diagram below).
Do not remove the caps on the flow transducer until the fuel hoses are ready to be installed.
The flow of fuel through the transducer must follow the direction marked on the transducer.
END VIEW UP
SIDE VIEW
If the transducer is higher
than the carburetor or fuel
servo, put a loop in the fuel
line between the transducer
and the carburetor or fuel
sevo.
¼ NPT
The direction of the fuel
flow through the transducer
is marked on top
Mount the
transducer
with the
wires up.
Carburetor or Servo