Owner manual

For Your Safe Flight Page 43
Hold both
buttons for 5
seconds until
the words
FAC LIM
Tap STEP
button until
the words
END Y
Hold both
buttons for 5
seconds until
the word
PROGRAM
The display will then sequence as shown in the chart below. Tap the
STEP button to advance to the next item in the list. Tap the LF button to
select alternate values of that item. Hold the LF button to increase a
numerical value; tap the LF button to decrease a numerical value. The
shaded areas in the chart below pertain only to the Fuel Flow Option.
Procedure for changing the larm limits or main tank capacity:
Tap STEP
to next item
LF sequences through
these value ranges
Description
FAC? N FAC? N  FAC? Y
Restore factory defaults?
ENG F ENG F  ENG C
Select F or C degrees for
all engine temps. You
must also change the
alarm limits to °F or °C.
I6.0 H BAT I0.0 H BAT … 35.0 H BAT
Battery high voltage limit,
set in 0.5 volt increments.
I2.0 L BAT 8.5L BAT … 30.0 L BAT
Battery low voltage limit.
500 DIF 30 DIF … 990 DIF
EGT difference limit, set in
10° increments.
450 H CHT 90 H CHT … 500 H CHT
CHT high limit, set in 5°
increments.*
-60 CLD -5 CLD … -200 CLD
Cooling limit, set in
5°/min. increments.
I650 TIT 650 TIT … 2000 TIT
Also sets the maximum
scale of the EGT and TIT
bar graph.*
230 H OIL 40 H OIL … 500 H OIL
Oil temperature high limit,
set in 5° increments.*
90 L OIL I0 L OIL … 250 L OIL
Oil temperature low limit
set in 5° increments
42.0 MAP 25MAP … 90 MAP
MAP overboost alarm
(EDM-800 only)