Owner manual

Table of Contents
Section 1 - Introduction 1
Product Features 1
Engine Data Management 2
Benefits of Proper Mixture Control 2
JPI Probes 2
Temperature and Mixture 2
Section 2 - Displays and Controls 4
Displays 4
Modes 7
Buttons 8
Parameter Scan— EDM-700 without Fuel Flow Options 9
Automatic Parameter Scan—EDM-711 10
Section 3 - Operating Procedures 11
Diagnostic Testing on Startup and During Flight 11
Modes 11
Automatic Mode 11
Manual Mode 12
LeanFind Mode—Leaning Rich of Peak 12
LeanFind Procedure—General Explanation 13
Operation for each Phase of Flight 18
Shock Cooling 19
Common Misapplications 20
Section 4 - Diagnosing Engine Problems 21
Alarms 24
Pre-Ignition and Detonation 25
Section 5 - Fuel Flow Option Operation 26
Fuel Flow Display Select Switch 26
Fuel Management 28
Parameter Scan—Systems with Fuel Flow Option 28
Section 6 - Long Term Data Memory 30
Downloading from Long Term Memory 31
Downloading Data from the EDM to a Flash Drive 31
Downloading from USB Flash Drive to a PC 33
Section 7 - Personalizing 33
Pilot Programming 33
Section 8 - Programming the EDM-800 Horsepower Constant 35
Section 9 - Programming Manifold Pressure (MAP) 35
Section 10 - Programming use of Factory Original TIT Probe 36
Section 11 - Programming the Fuel Flow Option 38
Fuel Flow Option Programming Procedure 40
Section 12 - Programming Long Term Data Memory 40
Section 13 - EDM-711 Primary Alarm Display 41
Section 14 - Alarm Limits 42
MAP, Fuel Flow Alarm Limits, Units, Fuel Capacity 44