Instruction Manual

Step 6.

Install the auger through the Talc Holding Container into the Talc Transfer Tube. Attach the motor to the auger

with the supplied set screw.

Attach the Motor to the Talc Holding Container using the supplied Exhaust Clamp. Tighten hardware once nished.

Note: When installing motor make sure the key-way is installed correctly.

Step 7.

Install both 1/4” x 107” Hydraulic Hoses from the Talc Motor to the Talc Control Valve Body. Hose coming

from Port A runs to Port 1 and Port B runs to Port 2. Route the hose through the conduit on the frame. Tighten

ttings once installed.

Step 8.

Use zip ties to fasten hydraulic hoses where necessary. Hose’s should be fastened where they will not rub any

moving components or catch any debris during transit.