Instruction Manual

Step 1.
Measure from the top of the shell frame and make a mark on the front right side leg at 35” for the Model 375
Seed Tender and 42” for the Model 275 Seed Tender. is mark is for the height of the Talc Holding Container.
Next using the Talc Holding Container as a guide, mark 2 holes on the side of the leg. Drill both holes with a
7/16” bit. Once the holes are drilled, fasten the Talc Holding Container with (2) 3/8”x 1” Serrated Flange Hex
Nuts and Bolts. Tighten the hardware once nished.
Step 2.
Using the Talc Control Valve Body Assembly mark (2) holes in the front le leg gusset. e bracket should be
placed at the highest point possible on the front leg gusset. Once marked, drill 2 holes with a 7/16” drill bit.
Attach the Control Valve Body Assembly with (2) 3/8” x 1” Serrated Flange Hex Head Nuts and Bolts. Tighten
hardware once nished.
42” (275ST)
35” (375ST)