Manual

7
R M
WARNING: When Servicing e Track System, Be Certain All Power To Grain Cart Is Shut O.
Repack the wheel bearings at least once a year. Use Bearing Gard MK1 or equivalent lubricant. Also check the
seal for wear and replace if necessary.
Check the track system periodically for cracks in welds and for other structural damage. Have cracked welds
xed immediately. Failure to do so could result in extensive damage to the track system and grain cart and great-
ly reduce the life of the equipment.
Lubricate the track system according to the Lubrication Service Schedule.
Make sure that all guards and shields are in place before operating the track system.
Check the pressure in the air spring aer every 100 hours of operation and at the beginning of each season. e
correct air pressure is 100 psi.
Check the wheel hubs and make sure the nuts are torqued to 350 . lbs. Check the hub nuts aer the rst
hour of operation, then every 10 hours of operation for the rst 40 hours of use. ese nuts must be kept
tight at all times. Wheels that are improperly installed and maintained, resulting in failure, will nullify the
warranty and shi the burden of liability to the owner/operator of the equipment.
TROUBLE SHOOTING
WARNING: Make sure all power is shut o to grain cart before servicing the track system. Maintenance and
repair service work to be performed by qualied servicemen only.
Trouble… Possible Causes… Possible Remedy…
Belt Guide Lugs Show Wear Misalignment Adjust Front Alignment Weldment
No Belt Tension Deated Air Spring Replace Air Spring (100 psi max.)