Manual

7
Rear Endcap Support Brace
Install the Endcap Brace. e purpose of the endcap brace is to hold the inside of the endcap up approximatley
1” higher than the outside of the endcap. Drill a hole using a 1/4” drill bit rst followed by a 7/16” drill bit. e
hole should be place onto the nearest crossbrace which is welded to the shell body. e hole should be located
somewhere between the middle of the endcap and the inside of the endcap. ere are two braces that can be used
to support the endcap. Some carts will need one brace and some will need two. Use the combination that rais-
es the inside lip of the endcap 1” above the outside edge of the endcap. Use 3/8” x 1” SF Hex Bolts and Nuts to
attach the braces to the grain cart.
1”
Tools Needed:
1/4” Drill Bit
7/16” Drill Bit
9/16” Wrench & Socket