Manual

13
Install Pop Rivets on Roll Tube
Install the Roll Tarp Stops
Line the roll tube spool up with the spring return cable. Drill a 1/4” hole through the rst stiening
patch. Fasten the canvas tarp using a pop rivet. Go to the rear of the cart, pull the canvas tarp tight, and
repeat the process. en install pop rivets at the remaining stiening patches. Once nished slip the
Spring Return cable loop over the spool.
Next place the 1” tube under the top bolt of the corner bracket. Drill a 1/4” hole approximatley 18” to 24” in
from the corner of the cart. en redrill the hole with a 7/16” bit. Place a 3/8” x 2”bolt through the 1” tube and
grain cart sidewall. Fasten with a 3/8” serrated ange nut. Now repeat this process at the front and middle of
the cart.
18”-24”
Tools Needed:
1/4” Drill Bit
7/16” Drill Bit
9/16” Socket & Wrench
Tools Needed:
1/4” Drill Bit
Hammer
1” Steel Tube