O P E R A T O R ’ S M A N U A L and Set-Up Instructions for HYDRAULIC AU G E R - MAT E AM-1 Auger-Mate (Briggs/Stratton Motor) AM-1ES Auger-Mate (Briggs/Stratton Motor w/Electric Start) AM-2 Auger-Mate (Honda Motor) AM-2ES Auger-Mate (Honda Motor w/Electric Start) J. & M. Mfg. Co., Inc. P.O. Box 547 Ft. Recovery, OH 45846 Ph: (419) 375-2376 Fax: (419) 375-2708 JMMAN0101 (Rev. 05/16/06) www.jm-inc.
TO THE DEALER: Read manual instructions and safety rules. Make sure all items on the Dealer’s Pre-Delivery and Delivery Check Lists in the Operator’s Manual are completed before releasing equipment to the owner. Online Warranty claims will be denied if the Warranty Registration Card has not been completed and returned. EXPRESS WARRANTY: J. & M. Mfg. Co. Inc. warrants against defects in construction or materials for a period of ONE year.
GENERAL INFORMATION BOLT TORQUE CHART Always tighten hardware to these values unless a different torque or tightening procedure is listed for a specific application. Fasteners must always be replaced with the same grade as specified in the manual parts list. Always use the proper tool for tightening hardware: SAE for SAE hardware and Metric for metric hardware. Make sure fastener threads are clean and you start thread engagement properly.
TABLE OF CONTENTS EXPRESS WARRANTY 2 BOLT TORQUE CHART 3 SAFETY SIGNS 5 SAFETY RULES 5-6 INITIAL OPERATION 6 PARTS LIST 7 SET-UP INSTRUCTIONS 8 SERVICE RECORDS 10 4
SAFETY SIGNS ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Replace Immediately If Damaged or Missing! IMPORTANT: Install new safety signs if the old signs are Ref. # destroyed, lost, painted over or cannot be read. When parts 1 are replaced that have safety signs, make sure you install a 2 new sign with each new part. New signs are available from 3 the manufacturer or your authorized dealer.
SAFETY RULES (continued) ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED! Hydraulic oil leaking under pressure can penetrate skin and cause infection or other injury. To Prevent Personal Injury: Relieve all pressure, before disconnecting fluid lines. Before applying pressure, make sure all connections are tight and components are in good condition. Never use your hand to check for suspected leaks under pressure. Use a piece of cardboard or wood for this purpose.
AUGER-MATE MOUNTING FRAME PARTS LIST # 1 2 3 4 5 6 7 8 Part # AMF-1 AFRP-1 12EL HH-34 12112HB 12LN FW-12 BB-2 9 123HB 10 PS-1 11 1552HF 12 1078 13 1074 Description Mounting Frame Reinforcing Plate 1/2" Elbow 1/2" x 3/4" Hyd.
INSTALLING THE AUGERMATE MOUNTING BRACKET STEP ONE: To install the Auger-Mate Mounting Bracket, drill four 1/2” holes in the end of the gravity wagon for each model size indicated below. MODEL 250-7S or 250-7SB Drill two sets of 1/2” holes (4 total) 39 1/4” apart in the end panels as shown. The first set of holes should be centered and located 2” above the top of the steel runners of the gravity wagon. The second set of holes should be located 4” directly above the first set of holes.
SERVICE / MAINTENANCE RECORD DATE DESCRIPTION NOTES 10
