Manual

17
PuSh Pull Weldment bar
SlIde bar Weldment (cont’d)
Attach the Push Pull Weldment Bar.
Slide the bar through the Slide Bar
Weldment. Use (2) 3/4” steel shoulder
screws and (2) 3/4” shoulder bolt nuts
to attach both ends of the Push Pull
Weldment Bar.
Install the interior hardware for
the Slide Bar Weldment. First
install the nylon washers around
the Push Pull Bar. Next, use (6)
1/4”-20 x 2” hex bolts and (6)
1/4” hex nuts to fasten the washers
around the push pull bar. Finish
with tightening the hardware.
Tools Needed:
1-1/8” Socket w/ impact
1-1/8” Wrench
Tools Needed:
7/16” Socket w/ impact
7/16” Wrench