User guide

1. Slide the weigh bar into the scale mount. Making sure that the Weigh bar sticker is facing up (Figure 6.1).

2. Insert two 3/8”-16 X 3 1/2” Grade 5 Zinc Hex Bolt (#1) into scale mount and tighten using 3/8”-16 Centerlock Hex Nut

(#2) (Figure 6.1).

3. Insert 4 Spacer Blocks in between the Shell/Leg Weldment and the Chassis Frame. Be sure the 4 Spacer Blocks are

 identicalinwidthandtsnugbetweentheShell/LegWeldmentandtheChassisFrame(Figure6.2).

4. Remove the 4 bolts from each of the Dummy Scale Mounts and remove it from the unit.

WARNING: With the 4 bolts removed from each of the Dummy Scale Mounts. The Chassis and Shell are not attached and

can slide apart.

5. Lift the shell approximately 2-3”. This will allow enough clearance to slide the weigh bars into the Shell/Leg

Weldment Spools. (Figure 6.2).

6. Slide Weigh Bars into the Shell/Leg Weldment Spools and lower the Shell/Leg Weldment down so the Weigh Bar Mounts

set on the Scale Mounting Plates.

7. Use a punch to align the Weigh Bar Mount holes with the Scale Mounting Plate holes.

8. Insert 1/2”-13 X 1 3/4” Grade 5 Hex Head Bolt (#3) with two 1/2” Zinc USS Washers (#4) and 1/2”-13 Grade 5 Zinc

Centerlock Hex Nut (#5) (Figure 6.3)

IMPORTANT: Be careful not to pinch wires between the Speed Tender chassis and the Scale Mounting Plates.

9. Torque each bolt down to 85 ft-lbs on all 4 Scale Mounting plates (Figure 6.3).

6.0 Aftermarket Installation Instructions

6.1 Scales Installation

Note: For Scale parts see Section 5.3

Figure 6.1

Figure 6.2

Figure 6.3

Spacer Block

Shell/Leg

Weldment Spools