User guide

26
2.0 Service
2.0 Service
Problems Solutions
Locking brakes
a. Replace any weak or broken springs in brakes
b. Replace any excessively worn or contaminated linings
Grabbing brakes
a. Replace any excessively worn or contaminated linings
Surging brakes
a. Trailer is not adequately grounded
Belt is not moving - Hydraulic pump is not producing
sufcientpressureorvolumetobeltmotor.
a. Check for pinched or leaking hydraulic line
b. Allow hydraulic oil to warm up
c. Increase engine R.P.M.
d. Charge battery or plug in to tow vehicle
e.Hydraulicuidlevellow
f.Hydrauliclterclogged
g. Check for proper oil viscosity
h. Check hydraulic output pressure.
Belt is not moving - Obstructed conveyer
a. Make sure conveyor is not clogged
BelthasinsufcientoutputspeedorR.P.M.-Hydraulic
pumpisnotproducingsufcientpressureorvolumetobelt
motor.
a. Check for pinched or leaking hydraulic lines.
b. Allow hydraulic oil to warm up
c. Increase engine R.P.M.
d.Hydraulicuidlevellow
e.Hydrauliclterclogged
f. Check for proper oil viscosity
g. Repair or replace worn out pump.
BelthasinsufcientoutputspeedorR.P.M.-Beltisslipping
a. Adjust belt tension and tracking (See section 2.8).
b. Check telescoping spout and conveyor for a clog.
c. Remove material from clean out door.
BelthasinsufcientoutputspeedorR.P.M.-Airin
hydraulic system.
a.Bleedairoutofhydraulicstemandllreservoir(See
section 2.6).
b.Lookforleakingorcrackedttings.
BelthasinsufcientoutputspeedorR.P.M.-Leakinmotor,
valve body, or bypass valves.
a. Replace or repair motor, valve body, or bypass valves.
b. Check for proper oil viscosity.