User guide

15
2.0 Service
2.3 Tire Pressure
Thefollowingistobeusedasageneralguidefortireination.Figurescanvarydependingonspecicbrandof
tire used. It is important that tires are inspected before and after unit is loaded. Start with the minimum pressure
indicated. The tire should stand up with no side wall buckling or distress as tire rolls. Do not exceed maximum
recommended tire pressure. 80 psi is the cold rating on the tire that is standard for the Speed Tender. J&M also
recommends to rotate your tires front to back (not side to side) every 1,200 miles or 12 months (whichever comes
rst)forlongertirelife.Firgure2.3belowisatroubleshootingchartusedtoensurethetireswearevenly.
2.4 Tightening Lugnuts
Torquelug-nutsonnewandremovedwheelsto220ft.lbs.aftertherst10,25,and50milesofdriving,then
rechecktorqueevery50hoursoreveryyear,whichevercomesrst.
Figure 2.3