Installation Guide

Installation

Hardware List

Table top

Table legs

Support frame

8x16mm screws

8x30mm screws

Washers

spare 4x15mm Self-tapping screws

Hexagonal screw tap

Place it as shown in figure 1, align the screw holes with 8x30mm screws and nuts

and tighten them. Note that the table legs should be as high as the support frame

from the ground, otherwise the table top installation will be affected.

8x30mm screw

PAGE 1
Installation Hardware List Hardware List 1 Table legs 4 Table top 1 4 8x16mm screws Support frame 16 20 Washers 8x30mm screws 8 1 Hexagonal screw tap spare 4x15mm Self-tapping screws 1 8x30mm screw Place it as shown in figure 1, align the screw holes with 8x30mm screws and nuts and tighten them. Note that the table legs should be as high as the support frame from the ground, otherwise the table top installation will be affected.
PAGE 2
8x16mm screw This is a spare screw hole. When the 8x16mm screw fails to be screwed in, the hole can be fixed with a 4x15mm self-tapping screw. Either way will do. Put the table top on the table leg, make sure the reserved screw holes of the table top and the frame are corresponding, tighten 8x16mm screws from the bottom to finish the installation.