Product Manual A

Maintenance Instructions

• Disconnect power before cleaning or maintaining your fan in order

to prevent serious injury or death.

• Service and repair of fan should only be completed by a qualified

technician.

• For maximum efficiency and fan life, keep the following free from

dirt and dust: blades, motor and guard.

• The totally enclosed air over motor has sealed ball bearings and

does not require additional oil/lubrication.

DISCONNECT POWER

BEFORE INSTALLING OR SERVICING.

ALL ELECTRICAL WORK SHOULD BE COMPLETED BY

QUALIFIED PERSONNEL AND MEET NATIONAL (NEC),

REGIONAL AND LOCAL ELECTRIC CODES.

! !

Connecting Power To The Unit

• Install manual disconnect switch inside

building adjacent to fan.

• Use either rubber covered or flexible water-

tight conduit and stranded wire.

• Route wire to motor with drip loop and

secure. Drip loop will drain accumulated

moisture away from the motor.

• Configure internal wires to match supply

voltage and wire according to motor

nameplate. Test to verify correct rotation.

• Shut off manual disconnect for remainder

of install. Only permit power to unit when

shutter and guard are fully installed to

prevent injury.

Using a #2 square drive bit reinstall the rear guard and clips that were

removed in Step 3.

Using a minimum of 12 fasteners suitable to your structure secure the unit

in the opening as shown below, 3 fasteners per side.

IS276-17I

J&D Manufacturing • 6200 Hwy 12 • Eau Claire, WI 54701 • 1-800-998-2398 • www.jdmfg.com

Page 3/3