User's Manual

Pressing the menu button(3) in the Time calibration menu allows you to
enter the alarm selection menu and you can select the Alarm OFF/Alarm ON
by using up/down button(5, 6).
If the alarm is on, Alarm icon ( ) is displayed and the radio makes a
alarm beeping at the set time.
3) Alarm time set
Pressing the menu button(3) in the Alarm selection menu allows you to
enter the Alarm time set menu, you can select hour/minute or AM/PM by
using menu button(2, 3) and change setting time by using up/down
button(5, 6).
3.3-7 STOPWATCH MODE
Pressing the mode/key lock button(4) in the Time mode allows you to enter
the Stop Watch mode .
You can operate the stopwatch by using the menu button(2, 3).
3.3-8 SETUP MODE
This mode is composed of 9 menus.
- “P-CH ” : Priority scanning channel selection
- “DLAY ” : VOX OFF DELAY TIME set
- “CALL ” : CALL beep sound selection
- “RING ” : CALL signal selection
- “ROGER ” : ending sound selection when transmission is ended
- “BEEP ” : key beep selection
- “QUIET ” : Quiet selection
- “TOT ” : Time Out Timer selection
- “NAME ” : User name(Unit name) set
Pressing the menu button(2, 3) allows you to select the menu, and then you
can change Menu’s state by using the up/down button(5, 6).
1) “P-CH ” : Priority scanning channel selection
Pressing the menu button(3) in the SETUP mode allows you to enter in the
priority scanning channel selection menu. You can select the Priority
scanning channel by using the up/down button(5, 6) except the setting
channel in TWO WAY mode.
2) “DLAY ” : VOX OFF DELAY TIME set
If voice signal is not transmitted when vox menu in TWO WAY mode is on, The
unit is transmitting for setting time(off/1second/2second/3second/4second/
5second).