User's Manual

3) SCAN selection
Pressing the menu button(2, 3) in the Channel/Code Selection menu allows
you to enter the Scan Selection menu with key beeping.
Pressing the up/down button(5, 6) in the Scan Selection mode allows you
to select Off,
Normal scan or Priority scan while icon is blinking.
If you select the Normal scan, it starts to scan the channel from the
current channel.
If you select the priority scan, it scans the current channel and priority
channel in turn. You can select Priority channel in setup mode.
4) VOX(Voice Activated Transmission) selection
Pressing the menu button(2, 3)in the Scan Selection menu allows you It
enter VOX selection mode with key beeping.
Pressing the up/down button(5, 6) in the VOX Selection mode allows you to
select Off/Hi/Mid/Low while icon is blinking.
No pressing PTT button(8), You can communicate voice to the other unit
using mic or ear mic.
If VOX function is selection, icon( ) is ligthed.
5) RF POWER AUTO / Low selection
Pressing the menu button(2, 3)in the VOX Selection menu allows you It
Enter PWR AUTO selection mode with key beeping.
Pressing the up/down button(5, 6) in the PWR Selection mode allows you
To select PWR AUTO,LOW .
3.3-2 FM RADIO MODE
This mode is composed of 4 menu and received FM broadcasting.
- FM Seek Scan : Auto selection
- FM Fine Tune : Passive selection
- FM Preset Memory : Broadcasting frequency memory
- FM only or Two Way : FM or GMRS selection
1) FM Seek Scan
Pressing the menu button (3) in the FM standby display allows you to
enter FM seek menu and you can scan the FM radio frequency by using the
up/down button(5, 6). If an active broadcast signal is detected, it
receives a signal in that channel.