User's Manual

3) “CALL ” : CALL beep sound selection
You can select call beep sound out of off/1/2/3/4/5/6/7 by using up/down
button(5, 6).
4) “RING ” : CALL signal selection
“ R ” : Only received call sound.
5) “ROGER ” : ending sound selection when transmission is ended
This menu decide that the unit transmit ending sound or not when
transmission is terminated.
6) “BEEP ” : key beep selection
This menu decide that beep sound is produced or not when key button is
pressed.
7) “QUIET ” : Quiet selection
It’s good that this menu is set “QUIET ON” when you use a earphone.
8) “TOT ” : Time Out Timer selection
The unit stops transmission If continuous transmission time is exceed for
setting time In this mode. You can select one out of off/30second/60second
/180second by using the up/down button(5, 6)
9) “NAME ” : User name(Unit name) set
It’s possible that you change in this menu.
Call beep sound is transmitted the other unit.
When you call the other unit ( Double pressing the PTT button(8) allows
you the selective calling the other unit.)
using letters : A~Z, BLANK, *, +, -, 0~9, <, >, ?
Press the menu button(2, 3), then “NAME OFF” is displayed on LCD monitor.
Pressing the up/down button(5, 6) allows you to select “NAME ON”.
The letter on the extreme left blinks If you press the menu button(3).
Pressing the menu button(2, 3) allows you to move the position of your
desired letter.
Pressing the up/down button(5, 6) allows you to change your desired
letter.