User's Manual

signal of weather channel.
(4) Weather receiving
1) If the weather channel is on, it receives the weather
channel.
3. Normal Scan
1) If the Normal Scan is on, it starts scanning all channels.
2) If a transmission is detected, it receives a signal for 5
seconds and then change to next channel.
3) Scan wait time is 5 seconds after receiving.
4) You can pause on any channel for 15 seconds while in the
channel Scan mode by pressing the PTT key during of a signal
for 5 seconds afterward.
5) When you make a transmitting during Scanning, if you are
receiving or in scan wait time, you transmit a signal in
that channel. Otherwise you transmit a signal in the channel
in which you start the scanning.
6) Pressing the monitor key shortly during receiving or scan
wait time allows you to move to next channel and pressing
and holding the monitor key for more than 1.5 seconds
deletes the current receiving channel in the scan list.
4. Priority scan
1) Priority scan allows the scanning of two different channels
at the same time.
2) If the radio receives a signal in the current channel, the
radio detects the priority channel every 5 seconds and the
radio receives a signal in the priority channel, detects the
priority channel continuously.
3) When you try to transmit a signal during Scanning, if you
are receiving or in the scan wait time, you transmit a
signal in that channel. Otherwise you transmit a signal in
the channel in which you start the scanning.
4) Pressing the Monitor key during scan wait time or receiving
allows you to switch to the next channel.
5. Monitoring
1) Pressing the Monitor key allows you to monitor the current
channel.
2) Monitor key does not operate during transmitting.
3) Pressing the Monitor key for more than 3 seconds enables to
monitor continuously. Pressing the Monitor key releases the
auto monitoring.
4) Changing the channel or receiving a signal release the Auto
Monitoring.
6. Power Save
1) After Radio is on, it does not save the power for 5 seconds.
2) After finishing transmitting or receiving, it does not save
for 5 seconds.
3) When code option is off, Auto Power Save operating abides by
the rule of 100ms/400ms(off/on) for 20 seconds after power
save is started and abides by the rule of
100ms/900ms(off/on) after 20 seconds when power save is
started.
4) When code option is on, Auto power save operation abides by